12000BPH Juice Filling Machine

Description

Washing Part:

1. Except the down framework, the transmission parts and some parts that must be made of special materials. Other parts are all made of stainless steel 304.
2. The roller bearing is made of stainless steel, the sealing ring is made of EPDM material, and plastic is made of UMPE.
3. The gripper is made of stainless steel, the position where hold the bottleneck is made of food standard rubber;
4. Rinsing time can be guaranteed for 4 seconds.

Filler Station:

1. The entire filler is micro negative pressure filling system .Unique re-flux design saves cost, convenient for external CIP (clean in place)cleaning system.
2. High accurate SUS304L construction filling nozzle, make sure high accurate filling level SUS304L liquid bowl, pipeline system .
3. Filling level adjustable by choosing different silicone gasket (quick change over parts) No bottles, no filling .
4. Butterfly type liquid bowl, with automatic water level controller.
5. The hot filling temperature 85-90 degrees, if the temperature is low than the setting value, the filling valves will stop and return the last beverage in filling valve to recycle tank and return to UHT again to sterilize with pump.

Capper Station:

1. Cap distributing chute is equipped with reverse cap stop and reverse cap pick-out mechanism.
2. Cap distributing chute is equipped with a photocell switch to stop the capper when there is no cap inside the chute.
3. The capper is equipped with inlet bottle detection switch.
4. Use waterfall or centrifugal cap cover machine.

Machine Parameters

Configuration List